Oracle 10g installation steps

Download the oracle RPM from the below URL

http://www.oracle.com/technology/software/products/database/xe/htdocs/102xelinsoft.html


[root@xerago999 Desktop]# rpm -ivh oracle-xe-univ-10.2.0.1-1.0.i386.rpm
Preparing... ########################################### [100%]
1:oracle-xe-univ ########################################### [100%]
Executing Post-install steps...
You must run '/etc/init.d/oracle-xe configure' as the root user to
configure the database.

[root@xerago999 Desktop]# /etc/init.d/oracle-xe configure

Oracle Database 10g Express Edition Configuration
-------------------------------------------------
This will configure on-boot properties of Oracle Database 10g Express
Edition. The following questions will determine whether the database should
be starting upon system boot, the ports it will use, and the passwords that
will be used for database accounts. Press to accept the defaults.
Ctrl-C will abort.

Specify the HTTP port that will be used for Oracle Application Express [8080]:

Specify a port that will be used for the database listener [1521]:

Specify a password to be used for database accounts. Note that the same
password will be used for SYS and SYSTEM. Oracle recommends the use of
different passwords for each database account. This can be done after
initial configuration:

Do you want Oracle Database 10g Express Edition to be started on boot (y/n) [y]:y

Starting Oracle Net Listener...Done
Configuring Database...

Starting Oracle Database 10g Express Edition Instance...Done
Installation Completed Successfully.
To access the Database Home Page go to "http://127.0.0.1:8080/apex"